There is no paint coming out of my airbrush
The needle could be wrongly tightened in the airbrush, please try the following: https://www.youtube.com/watch?v=D9h_zTNF12Y
There could be a problem with the nozzle, please try the following:
https://youtu.be/VbM5dCYvbKg
Troubleshoot: https://www.youtube.com/watch?v=-uU42yToQX0
In case the airbrush is cleaned well, and the suggestions above don't work either, feel free to contact us.
Air is leaking out of my compressor AS-196
There could be some dirty residue inside the compressor, please try the following:
(make sure there is no more pressure on the compressor before you do this)
https://www.youtube.com/watch?v=wZ9K3DwCY9c
https://www.youtube.com/watch?v=HV12-XuhKeM
Because this is more of an act of cleaning and not or repair, this will not impact your warranty.
If this solution doesn't work feel free to contact us.
How to exchange the pressure switch on the compressor
https://www.youtube.com/watch?v=IPdqDeK49Kk
The pressure switch is for sale on our website.
My nozzle broke and a piece of thread is stuck inside the airbrush.
The steps to remove the thread are as follows.
Stap 1: Take the needle out of the airbrush
Stap 2: Push the needle into the mouth of the airbrush and against the broken nozzle, press slightly
Stap 3: Turn counter clock-wise, you should be able to take the nozzle out easily now.
My compressor gets very hot, is this dangerous?
This is not dangerous, the heat is a normal byproduct of decompressed air.
The compressor also has an automatic shut-off, this means it will shut itself of before dangerous temperatures can be reached.
To prevent too much heat build up it is advised to let the compressor cool down for a few minutes after about 20 minutes of use.
